Soot, smoke and charred wiring removed by a licensed crew

Electrical Fire Cleanup in SUNLAND, California Done Right

Electrical Fire Cleanup in SUNLAND, California starts with stopping the damage from spreading. We pull soot off every surface, neutralize the acrid smoke smell, and get your power back to code. Our electrical fire damage restoration in SUNLAND handles the whole job, from the panel to the attic insulation, so you are not coordinating three different contractors. Call (833) 929-6186 and we roll a truck.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Fire Damage Restoration Sunland — your local Fire Damage Restoration team
Careful work. Honest options.
About this service

What Electrical Fire Cleanup in SUNLAND, California Covers

Electrical Fire Cleanup in SUNLAND, California is the specialized removal of soot, char, smoke residue and contaminated materials left behind after a wiring, outlet, panel or appliance fire. It is not the same as a general house cleaning. Burning PVC wire insulation leaves a corrosive chloride residue that etches copper, brass and appliance circuit boards within days. We use a thermal imaging camera to find hidden hot spots inside walls, a moisture meter to catch water from firefighting, and HEPA vacuums with Fiberlock encapsulant to lock down fine carbon dust before it migrates through the HVAC system.

Most electrical fires in this area start small: a backstabbed outlet in a 1950s ranch home, an overloaded power strip behind a TV, or aluminum branch wiring in an older Sunland-Tujunga property. The fire may be out in minutes, but the smoke odor lingering in cabinets, closets and ductwork can last months if the residue is not chemically neutralized. If you are searching for professional electrical fire cleanup near me SUNLAND, we handle both the visible char and the invisible contamination in one mobilization.

  • ✓ Corrosive Soot Stopped
  • ✓ Odor Gone, Not Masked
  • ✓ Insurance-Ready Paperwork
  • ✓ Power Restored to Code
What's included

What Electrical Fire Cleanup Includes

Every job starts with an assessment and a written scope, then moves through soot removal, odor treatment, dry-out and rebuild. The inclusions below are standard on every electrical fire loss. If your job needs something outside this list, it shows up in the scope before we start, not as a surprise on the invoice.

✓

Emergency Board-Up and Tarping

We secure open walls, windows and roof penetrations so weather and animals stay out. This happens on the first visit, usually within hours of your call, and it is what protects the rest of the structure while the claim is being processed.

✓

Soot and Char Removal

HEPA vacuuming, dry chemical sponge cleaning and removal of charred drywall, insulation and lumber. Contaminated material is bagged and hauled to an approved disposal site, not left curbside for weeks.

✓

Odor Neutralization

Hydroxyl generator and ozone treatment on a timed cycle, plus fogging of wall cavities and ductwork. We verify with a sniff test before equipment is removed, and we re-treat if the odor returns within the warranty window.

✓

Structural Dry-Out

Firefighting water hides in framing and subfloor. Industrial dehumidifiers and air movers run 3 to 5 days until moisture meter readings hit dry standard, which prevents mold growth after fire from becoming a second claim.

✓

Smoke Sealant and Encapsulant

Fiberlock encapsulant and smoke sealant primer lock residual soot particles into the surface so they cannot off-gas later. This is the step most cheap cleanups skip, and it is why their smell comes back.

✓

Rebuild and Circuit Testing

New drywall, insulation, trim and paint to match, plus replacement of melted wiring and testing of every repaired circuit against California Electrical Code before we sign off.

How it works

What to Expect During the Cleanup

01

Emergency Board-Up

We arrive, secure the structure, and tarp any roof or wall opening so weather and animals stay out. The first hour is about stopping secondary damage. We shut off the affected circuits, photograph everything for the claim file, and give you a verbal scope before we touch a wall.

02

Soot and Char Removal

Technicians in PPE use HEPA vacuums and dry chemical sponges to lift loose soot from ceilings, walls and framing. Charred drywall, insulation and lumber come out with a pry bar and drywall saw. Contaminated material gets bagged and hauled, not left in your side yard.

03

Deep Clean and Seal

Every remaining surface gets washed with a restoration-grade cleaner, then sealed with smoke sealant primer. This is the step that stops the smell from coming back. We fog wall cavities and ductwork, then run air scrubbers and negative air machines to pull fine particles out of the air.

04

Dry-Out and Odor Treatment

Firefighting water hides in framing and subfloor. Industrial dehumidifiers and air movers run for 3 to 5 days until moisture meter readings match dry standard. Hydroxyl generators run continuously during this phase to break down odor molecules without leaving a chemical smell behind.

05

Rebuild and Walkthrough

We hang new drywall, tape, texture and paint to match, replace insulation and trim, and test every repaired circuit. The final walkthrough is with you, not the insurance adjuster, and we do not close the file until you sign off on the smell test and the finish work.

Tools & methods

Tools and Methods We Use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Thermal Imaging Camera

Finds hidden hot spots and compromised wiring inside walls before we open them, so we are not guessing where the heat traveled.

HEPA Vacuum

Lifts fine carbon dust and soot from surfaces without blowing it back into the air. The first line of defense against cross-contamination.

Air Scrubber and Negative Air Machine

Pulls airborne particles out of the room and maintains negative pressure so soot does not migrate into clean areas of the house.

Hydroxyl Generator and Ozone Generator

Breaks down smoke odor molecules at the molecular level. Hydroxyl runs safely during occupancy; ozone runs on a timed cycle in unoccupied spaces.

Industrial Dehumidifier and Air Mover

Dri-Eaz and Phoenix Restoration Equipment units pull firefighting water out of framing and subfloor before mold growth after fire starts.

Moisture Meter

Documents dry standard in framing and subfloor so the dry-out is verified with numbers, not guesswork.

Drywall Saw, Pry Bar and Sledgehammer

Controlled demolition of charred drywall, insulation and lumber. The right hand tool keeps the cut clean so the rebuild patch is smaller.

Real results

Before and after.

Hallway Outlet Fire, Sunland-Tujunga

Before

A backstabbed outlet failed at 11 p.m. and scorched a 4-foot section of hallway wall. Soot covered the ceiling and drifted into two closets. The smell was sharp and getting worse each day.

After

Charred drywall and insulation removed, cavity HEPA vacuumed and sealed, outlet and wiring replaced, wall patched and painted to match. Hydroxyl treatment ran 4 days. Final sniff test passed on day 5.

Panel Fire, Sunland Boulevard Corridor

Before

A commercial panel fire filled a retail suite and two neighboring units with smoke overnight. Inventory in the back room was coated in fine soot, and the shared HVAC system was pulling the smell into adjacent suites.

After

Affected suite isolated, shared ductwork treated, inventory cleaned and documented, panel replaced and circuits tested. Neighboring units stayed open during the work. Rebuild finished in 12 days.

Attic Fire, Haines Canyon

Before

Knob-and-tube wiring in the attic ignited insulation and charred 30 feet of framing. The fire was out quickly, but smoke had soaked into the roof deck and the attic smelled like burnt plastic.

After

Charred insulation removed, framing treated and sealed with smoke sealant primer, damaged wiring replaced, attic re-insulated to current code. Moisture readings verified dry before insulation went back in.

Problems we solve

Problems We Solve After an Electrical Fire

The fire is the obvious problem. The ones that cost you money later are the acid residue, the hidden water and the smoke that soaks into framing. Here is how we handle each.

Ask a pro →
01

Smoke odor lingering months after the fire

We fog wall cavities, run hydroxyl generators on a timed cycle, and seal surfaces with smoke sealant primer. The odor is broken down at the molecular level, then verified with a sniff test before equipment comes out.

↗
02

Soot residue etching metal and appliances

Our crews neutralize surfaces with restoration-grade cleaner and Fiberlock encapsulant on the first visit. We clean appliance exteriors and HVAC coils before the acid has time to do permanent damage.

↗
03

Water damage from firefighting

We map moisture with a moisture meter, set industrial dehumidifiers and air movers, and monitor daily for 3 to 5 days. Dry standard is documented before rebuild starts.

↗
04

Melted wiring and unknown circuit damage

We trace affected circuits with a thermal imaging camera, replace melted wiring, and test every repaired circuit before power is restored. Repairs are made to current California Electrical Code.

↗
Proof you can check

Licensed, Certified and Documented

✓
IICRC Fire and Smoke Restoration Technician (FSRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Odor Control Technician (OCT)Institute of Inspection, Cleaning and Restoration Certification
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
✓
OSHA 10-Hour ConstructionOccupational Safety and Health Administration
✓
California Contractors State License Board (CSLB) LicenseCalifornia Contractors State License Board
Good questions

Frequently Asked Questions

(833) 929-6186 →

Most residential electrical fire cleanups in SUNLAND run $3,200 to $12,500 in 2026, with small outlet fires at the low end and panel or attic fires with structural rebuild at the high end. Cost drivers are square footage affected, whether drywall and insulation must be removed, how much firefighting water needs drying, and whether the repair touches framing. We write a line-item scope before demolition so you see the number before the work starts.

Fire Damage Restoration Sunland does, and we have been doing it since 2022 from right here in the Sunland-Tujunga area. We are CSLB-licensed, IICRC FSRT and OCT certified, and we handle cleanup, dry-out, odor treatment and structural repair in-house. Call (833) 929-6186 and a crew can be dispatched the same day for most addresses along Foothill Boulevard and the surrounding canyons.

Yes, most standard homeowner policies in California cover sudden electrical fire damage, including soot cleanup, smoke odor treatment and the rebuild. What is usually excluded is the failed wiring or appliance that caused the fire, and any damage from long-term neglect. We document the loss in Xactimate format, photograph affected materials, and can talk directly to your adjuster to keep the claim moving.

A single-room outlet fire typically takes 3 to 5 days from board-up to final walkthrough. Larger panel or attic fires with structural rebuild run 2 to 4 weeks, mostly because dry-out takes 3 to 5 days and drywall and paint need cure time. We give you a written schedule after the initial assessment and update it if hidden damage changes the scope.

Ready when you are

Get Electrical Fire Cleanup in SUNLAND, California Today

Soot starts etching metal within 48 hours, so the clock is already running. We are licensed, insured and bonded, and we dispatch 24/7 for fire losses across SUNLAND. One call gets a crew moving and a written scope in your hands.

Call Now (833) 929-6186 →
Request an appointment

Contact Our SUNLAND Fire Damage Restoration Team

Call (833) 929-6186 any hour of the day or night and a real person picks up. We dispatch crews 24/7 across SUNLAND and the surrounding foothills, and most calls get a technician on site within 60 to 90 minutes. If you prefer email, send photos and your address to info@firedamagerestorationsunland.com and we will follow up the same day.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186